.50ASSEMBLY • OPERATION • MAINTENANCE • PARTS20" REAR DISCHARGE ROTARY MOWERImportant:Read Safety Rules and Instructions CarefullyModel Number 11
OPERATIONDO NOT OPERATE THIS MOWER WITH THE CHUTE DOORS OPEN, UNLESS THE COMPLETE GRASSCATCHER IS PROPERLY MOUNTED ON THE MOWER.FIGURE 15
I WARNING {Unless the entire grass catcher is correctly positioned on the mower, do not open the discharge chute doors when the engine i
c. Turn needle valve back In clockwise very slowly till engine runs evenly.d. Final adjustment of the needle valve should be slightly to
DECKThe underside of mower deck should be cleaned after each period of use as grass clippings, leaves, dirt and other matter will accumulate. Th
BLADE BRAKE/CLUTCHThis unit is equipped with a blade brake/clutch. If for some reason the blade brake/clutch becomes inoperative, it is suggested that
Hex Nuts, Lock Washers and Carriage BoltsFIGURE 25.Remove the center bolt as follows.Insert a screwdriver into the slot provided in the blade brake
2. Drain all the oil from the crankcase (this should be done after the engine has been operated and is still warm). Refill the cr
NOTEThe use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer is not recommended.^ WARNING ^
<00cococo
111-338APARTS LIST FOR MODEL 111-338A4ef.PART COLORNEWREF.PARTCOLORDESCRIPTIONNEWNO.NO.CODEDESCRIPTIONPART NO. NO. CODEPART1731-0527 Clutch Control Ha
INDEXSafe Operation Practices ...3Assembiy...4Contro
111-338APARTS LIST FOR MODEL 111-338AREF.NO.PARTNO.COLOPCODEDESCRIPTIONNEWPART1710-0117Hex Bolt 5/16-24 X 1.00" Lg.*2 712-0305Hex Cent. L-Nut 5/1
PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the authorized
^ WARNING \To reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions may result i
SAFE OPERATION PRACTICES (Continued)2. Keep all nuts, bolts, and screws tight to be sure the equipment is in safe working condition.3. Neve
3. Place lower handle in position over weld pins in handle mount brackets on deck. Secure by placing two hairpin cotters (C) in inner hole on — weld
(D)5. Secure throttle control cable and blade brake/clutch cable to handle with cable ties— (D) provided. See figure 5.6. Check all nuts and bolts f
1:^Cotter Pins (|h)3. Stand bag on end with open end up. Pull bottom of bag forward Into slot. Align holes and slip cotter pins (H) into holes. Sprea
FIGURE 9.To Attach Bag To MowerThe doors shown in figure 9 cannot be opened to discharge the grass unless the grass catcher is in -place.^ WARNING IUn
2.----Pull cam lever back and down to lock grass catcher on mower. This automatically opens ------rear discharge doors on mower.To remove the grass ca
Comments to this Manuals