$1.0028" TILLER ATTACHMENTModel Numbers190-746-00019746TMO-33603BIMPORTANT: Read Safety Rules and Instructions Carefully ^Thank you for purchasin
Model 746 and19746LAWN TRACTOR FRAMEENGINE PULLEYPARTS LIST FOR MODEL 746 28" TILLER ATTACHMENTREF.NO.PART NO.DESCRIPTIONNEWPARTREF.NO.PART NO.DE
Model 746 and 1974f>LIFT LEVER41 42NOTESpecifications subject to change without notice or obligation.12
Model 746 and 19746PARTS LIST FOR MODEL 746 28" TILLER ATTACHMENT8EF.NO.PART NO. DESCRIPTIONNEWPARTREF.NO.PART NO.DESCRIPTIONNEWPART1 710-0696 He
Model 746 and 1974(>14
Model 746 and 19746PARTS LIST FOR CHAIN CASE ASSEMBLY COMPLETE 884-0061-5REF.NO.PART NO.DESCRIPTIONNEWPARTREF.NO.PART NO.DESCRIPTIONNEWPART105034Beari
REPLACEMENT PARTS • P.O. BOX 360900 • CLEVELAND, OHIO 44136
AIMPORTANTRULES FOR SAFE OPERATIONTHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSO
Rules for Safe Operation (continued)25. Keep the vehicle and attachments in good operating condition, and keep safety devices in place. Use
IDLER BRACKET ASSEMBLY (V)FIGURE 3Remove the cutting deck from your tractor if one is attached.Preassemble the idler bracket support arm
10.11.Secure end of idler bracket support arm assembly on the right side of tractor with one flat washer (D) and hairpin cotter (J).Plac
16.17.18.FIGURE 8FIGURE 9Place the large compression spring (U) over the slotted end of lift rod assembly (W).Place slotted end of lift rod (with spri
23. Secure the weld pin on the left hand side of tiller using one flat washer (D) and hairpin cotter (J). See figure 11.FIGURE 1124. Move t
DRIVE PULLEY27.FIGURE 14Assemble the belt as follows (refer to figure 14).A. Belt is attached to the idler pulley assembly. Back of the bel
CONTROLSLeverI ne lift lever which is used to raise and lower the tiller and provide tilling depth adjustment is located on the righ
Comments to this Manuals