$1.00OWICIPSGUMASSEMBLY • OPERATION • MAINTENANCE • PARTS21"ROTARYMOWERSModel Numbers 111-516R000 111-518R000/9Û-07Î-0Œ) ¡¡Mb 1%-ûlî-ÛQÙ ^QFTImp
2. Open fuel shut-off valve (if so equipped). Flefer to separate engine manual.3. Move throttle control lever all the way forward.4. Tecumseh engi
NTHROHLE CONTROL ADJUSTMENTIf the throttle control requires adjustment or if it has been replaced, adjust as follows.1. Remove the screw shown in fig
When sharpening the blade, follow the original angle of grind as a guide. It is extremely Important the t each cutting edge receives an equal amount o
•For faster service obtain standard nuts, bolts and washers locally. If these items cannot be obtained locally, order by part number and size as shown
Models 516R and 518ROPTIONAL HUB CAPSDescriptionPart No.Gray (5-1/2" Dia.) Beige (5-1/2" Dia.) Gray (3-1/2" Dia.) Black (1-1/2" Di
PARTS LIST FOR MODELS 516R AND 518R ROTARY MOWERSREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1747-0748Control Handle Ass’y- (Std.)52710-
TROUBLE SHOOTING GUIDETroublePoss ble Cause(s)Corrective ActionEngine fails to start1. Blade control handle disengaged.2. Spark plug wi e disconnect
IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRl ICTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AN
----- J-------------------------------------------------------------------Ml i nis Line---------------------------------------------------------------
CONTENTS OF HARDWARE PACKRemove this sheet from your owner’s manual and lay the hardware on the illustration for identification purposes. After assemb
ASSEMBLY INSTRUCTIONS\ IMPORTANT: This unit is shipped WiTHOUT GASOLINE or OIL. After assembly, service engine with gasoiine and oii as instruct
ATTACHING THE BRAKE CABLE1. The brake cable is attached to the engine, and has a “Z” fitting on the loose end. Route the brake cable below the lower
FIGURE 7.—Optional Hub Caps5. Thread axle bolt into rear hole of pivot bar. Tighten securely.6. Assemble other rear wheel in the same manner.INSTALL
4. Attach the hardtop cover to the grass catcher as —follows. See figure 10.a. Place the cover in position on top of the grass catcher. Press the re
CONTROLS\FIGURE 13.BLADE CONTROL HANDLEAWARNING: This control mechanism is a safety device. Never attempt to bypass its operations.The blade control
Comments to this Manuals