28" TILLER ATTACHMENTNModel Numbers 190-756-000 190756IMPORTANT: Read Safety Rules and Instructions CarefullyThank you for purchasing an American
OLi JотШжгтшж^элэт «п11
Model 756190756PARTS LIST FOR MODEL 756 28 ' TILLER ATTACHMENTREF.NO.PARTNO.CODE DESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1710-0696 Hex Bolt 3/8-2
Model 756190756Lauti TractorPARTS LIST FOR MODEL 756 28" TILLER ATTACHMENTREF.NO.PARTNO.CODE DESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1710-0427Hex
Model 756190756NOTE: Torque setting for the limited torque clutch is 350 in. lbs.32° GreaseLubricate with 20 oz. of Piastiiube #0 Grease. Order
N
For Remplacement Parts, Contact:SERVICE DEPARTMENT • P.O. BOX 368022 • CLEVELAND, OHIO 44136-9722
IMPORTANT AASAFE OPERATION PRACTICESTHIS SYMBOL POINTS OUT IMPORTANT SA -ETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY
N4. Never tamper with safety devices. Check their proper operation regularly. Use all guards as instructed in this manual.5. To reduce fire hazard, ke
FIGURE 2.Use This Hole For Mounting Idler Bracket Support ArmSupport Pivot Bracket (CC)HammerAil Other TractorsSupp< >rt Pivot Bracl:et (CC
sHex Bolts (E) Lock Washers (F) Hex Nuts (G)NFIGURE 56. Align the holes in the support pivot bracket with the holes in the tractor frame. Secure the
15. Place the tiller in position behind the tractor.16. There is a weld pin on the front of the tiller on the right hand side. Push the tiller forwa
NFlatX "^Washer (C) ^Hairpin Clip (J)21. Move the lift lever on the tractor to the second notch on the index bracket as shown in figure 11.22.
25. Assemble the belt as follows (refer to figure 13).A. Belt is attached to the idler pulley assembly. Back of the belt (flat side) goes against th
ADJUSTMENT FERRULEThe adjustment ferrule on the lift rod assembly provides additional tilling depth adjustment. Recommended adjustment is as fo
Comments to this Manuals