.5020" ROTARY MOWERSImportant:Read Safety Rules and Instructions CarefullyThank you for purchasing an American built product.Model Numbers111-060
4. Be sure that lawn is clear of stones, sticks, wire, or other objects which could damage lawn mower or engine. For best results
^ WARNING \If any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clutches and blades.
1. Remove the large bolt and lock washer which holds the blade and adapter to the engine crankshaft. See figure 16.2. Remove the bla
ENGINE OILCheck oil level before starting engine and after every 5 hours of operation.ADD oil as necessary to keep level FULL TO POINT
USING YOUR ROTARY MOWERFor the best results do not cut wet grass because it tends to stick to the underside of the mower, thus prev
NOTEThe manufacturer DOES NOT recommend the use of any accessory on this Rotary Mower other than those manufactured by the mower manufac
111-060A 111-062A 111-064A 111-066A 111-068AIF YOU WRITE TO US ABOUT THIS ARTICLE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & S
PARTS LIST FOR MODELS 111-060A, 062A, 064A, 066A and 068AREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1 720-0157G
PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the authorized
INDEXSafe Operation Practices... 3Handie identification ...
^ WARNING ITo reduce the potential for any injury, comply with the following safety instructions. Faiiure to compiy with the instructions may result i
HANDLE IDENTIFICATIONHairpin (T) HandleThe hairpin (T) handle will mount to the deck with shoulder bolts, nuts and lock washers.For models
B—► , ( • 1J If il if c^J _:|1 E—D——• '' 1« • Mt --WM' ' ' 'll/i, r,,ij )i J-K-I) uList of Contents in Hardware P
FIGURE 3.FourCuttingHeightsASSEMBLYINSTRUCTIONS (Hairpin (T) Handie)NOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see ope
Upper Handle -----Halves. -V •iffHex Bolts (B)Hex Bolts (B)FIGURE 5.Hex Lock Nut (D)8. Assemble the upper handle halves to lower handle using five h
InnerHoleWeld PFIGURE 8.ASSEMBLYINSTRUCTIONS (Loop Handle)1. Extend throttle control which is attached to the engine at the rear of the
\5. Secure throttle control cable to handle with cable ties (R) provided. See figure 11.6. Check ALL nuts and boits for correct tightnes
Comments to this Manuals