Bolens 124-848L401 User Manual

vaRD-MaNOUTDOOR POWER EQUIPMENT for all seasonsOwner’sManual• SET-UP• OPERATION• MAINTENANCEIMPORTANT:Read Safety Rules and Instructions Carefully21&q

NOTE: When tipping the unit, empty the fuel tank and keep engine spark plug side up.TROUBLE SHOOTINGRefer to page 12 of this manual for trouble shooti

6. Remove the inside belt guard by removing two self-tapping screws. A 3/8“ wrench is required. See figure 17.FIGURE 18.7. Loosen (do

TROUBLE SHOOTING GUIDETrouble Possible Cau se(s)Corrective ActionEngine fails to start 1. Blade conti ol handle disengaged.2. Spark plug wire discon

USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY.C9CO. SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE A POWER POLEA CORNE

TWO YEAR LIMITED WARRANTYFor TWO YEARS from the date of retail purchase within the United States of America, its possessions and territories, YSRD-M

The only way to insure the perforinance of your product is to use original equipment parts and accessories, which are desi jned a

IM PO RTANTSAFE OPERATION PRACTICES▲THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY A

SET-UP INSTRUCTIONSIMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL in the engine. Be certain to service engine with gasoiine and oii bef

TO ATTACH BAG TO MOWER1. Hold the chute door on the catcher panel open as shown in figure 2.2. Slide the frame of the grass catcher down into the ch

RibsRearPanelRearDischarge Chute AssemblyShoulder BoltTO CONVERT MOWER TO A MULCHERTo use your mower as a mulcher, proceed as follows.1. Remove eithe

THROTTLE CONTROLThe throttle control is located on the left sic e of the upper handle. It is used to regulate the engine speed.AWARNING: The throttle

TO START ENGINE AND ENGAGE BLADESelf-Propelled Models Only:IMPORTANT: Move the shift lever only when the engine is running. Shifting the speeds

nine cutting height positions. Push the hand e to the left and then either forward to lower the cuttir g height or backward to raise the cutting heigh

THROTTLE CONTROL ADJUSTMENTIf the throttle control requires adjustment or if it has been replaced, adjust the throttle control as follows.1.